LABO-F012-I/U/F/C | flow transducer
Product.Nr.: LABO-F012-IUFC
Manufacturer: Senseca (ehemals Honsberg)
EUR 388,00
incl. 19 % VAT
product description
General information:
The sensors of the LABO-F012 family are used for monitoring of non-viscous fluids (for gases upon request). They are fully equipped with electronics in a sensor housing with a diameter of 12 mm and a M12x1 round plug outlet. The 16-bit processor carries out temperature compensation and linearisation of the calorimetric signal (measurement of the heat removal at the sensor tip due to the flowing medium).
The LABO-F012 electronics transmit the result as:
- Analog signal 0/4 mA to 20 mA (LABO-F012-I)
- Analog signal 0/2 V to 10 V (LABO-F012-U)
- Frequency signal (LABO-F012-F) or
- Pulse output / x litre (LABO-F012-C)
A model with switching output is available under designation LABO-F012-S.
If desired, the range end value can be set to the currently existing flow using "teach-in". If the transmitter is ordered in a specific T-piece, it can also be adjusted in l/min. Here, it should be noted that the flow speed is measured at only one point in the tube cross-section.
- Complete transmitter in 12 mm housing
- For various nominal widths of tube the same transmitter
- Signal proportional to the flow speed
- 4...20 mA or 0...10 V or frequency output
- Adjustable working range
- User-configurable via plug pin (teach-in)
- Can be used for various tube cross-sections
- Simple to use
Specifications:
| Appliance: | flow, control |
| Medium: | water (oils and gases upon request) |
| Measuring range: | 2 cm/s to 150 cm/s (water), 3 cm/s to 300 cm/s (oil) |
| Connection: | plug-in sensor Ø12 mm |
| Basic data: | PN 40 bar (stainless steel pinch screwing), PN 10 bar (plastic cone with union nut), temperature of medium -20°C to +70°C |
| Electrical data: | supply voltage 24 V DC ±10 % power consumption <1 W |
Downloads
data sheet English (1.37 MB)
data sheet German (1.43 MB)
